Take out the printer from the sealed box with all its key components i.e. cables, cartridges, etc.
The next thing to do is, remove the polystyrene packaging wraps with the orange tapes along with the plastic covering from the printer.
The first thing for hardware setup is to find out the power socket on the printer. As mentioned in Canon Ij Setup guide, plug the power cable to the wall socket and then to the printer’s port.
After that, switch the printer on by pressing the power button. And you will find the printer’s display light on.
For inserting the ink tanks, remove the cartridges outlet seal and the plastic covers covering it.
The printhead carriage will adjust itself once you open the top cover of the printer. Put all the cartridges and put them into their correct slots.
After putting the cartridges into the slots, close the printer top cover and suddenly you will observe that the printer will start making noise. This is the indication that ink cartridge installation is successfully done.
After then, open the flap of the printer and then pull out the input tray and then, put some pages into the paper tray.
Put the paper tray back to its place properly.
This finally finishes the configuration of your Canon Printer via .
1. The Canon printer gets delivered in a sealed enclosed box. Take out the printer and other components like cartridges, cables etc from the box.
2. Now remove the polystyrene packaging wraps, all the orange tapes and protective plastic from the display of the printer.
3. To set up hardware, locate the power socket on the printer. Now connect the power cable to the printer’s port and to the wall electrical outlet.
4. Now switch on the printer by pressing the power button. The printer display light will turn on instantly.
5. Remove the cartridges outlet seal and plastic covers covering the cartridge then insert the ink tanks.
6. Open the top cover of the printer so that the printhead carriage can adjust automatically to its place.
7. Now take all the cartridges and place them into their respective slots.
8. Close the printer cover and you will acknowledge that it starts making noise which means ink cartridge installation has been completed successfully.
9. Open the flap from the back of the printer and carefully pull out the input tray. Then place some pages into the paper tray.
10. Move the paper guides and insert a few pages into the feeder. Now push the paper tray and fit it back into its place correctly. Your hardware setup is completed successfully.
Regards, J Wick